Programming A Locomotive’s Decoder Address
1. Place the locomotive to be programmed on the program track. For
information on creating a programming track see page 5.
2. Press both the Forward and Reverse buttons at the same time to
access the Menu system.
3. Press the "+" or "-" button to select the program menu, PRO, then
follow the directions below and upper right:
Display
What To Do
Press Enter to access the Programming Menu.
When you enter the Programming Menu register 1, r 1, is displayed.
To program your locomotives address press Enter. To select a
different register use the “+” or “-” buttons.
To read the current value of the selected register, press Enter
(in this example, the current locomotive address). If the
register is read successfully, the locomotives address will be
displayed.
In this example the current address is 24. If there is a problem
reading the current value or setting a new value, an error will
be displayed (see page 26 for error definitions).
To change the current value (in this example the locomotive
address), use the “+” or “-” button to select the new address.
The range for locomotive addresses is 1 to 255. Please note the
Commander can not access addresses above 99. (Consult your
decoder manual for acceptable settings for other registers.)
Once you have selected the new value, Press Enter to set the
new value. If the new value is accepted, the new setting is
displayed. In the case of an error message, see page 26 for
definitions.
Press Exit to return to the Register selection menu. You may
then select another register using the “+” or “-” button, or
Press Exit to return to the System Menu.
Direct Mode Programing
When you enter the program menu on the Commander, the Commander
defaults to Register Mode for programming. If your decoder supports Direct
Mode programming the Commander will allow you to access any of the
Configuration Variables supported by your decoder.
To access Direct Mode you must first read any of the basic eight registers.
When you read any of the registers, the Commander performs a test to deter-
mine if your decoder supports Direct Mode. If your decoder supports Direct
Mode, you may access its CV's by following the steps below:
1. Place the locomotive on the program track.
2. Press both the Forward and Reverse buttons at the same time to
access the Menu system.
3. Press the “+” or “-” button to select the program menu, PRO, then
follow the directions on the next page:
17
18
(261 paginas)
(92 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales