Void INFINITE QX 6 Manual de instrucciones descargar pdf (Pagina 14)

Display What To Do

Press Enter to access the System Menu.

Use the “+” or “-” button to select the XpressNET address

menu.

Press Enter and the current XpressNET address is displayed.

Use the “+” or “-” button to select a different address. The

range is from 1 to 31. Each XpressNET device must have a

unique address.

Press Enter to accept the new value, and to return to the

locomotive display.

While a Slave Commander is connected to the XpressNET, you will see one

additional selection in the System Menu.

Display

What To Do

Displays the version number of the Master Commander.

This is a read only selection.

CHARACTERISTICS OF THE SLAVE COMMANDER

• The Slave Commander cannot be used to power the track.

• The Slave Commander does not require a connection to a Generator to

operate. However if you do connect a Slave Commander to a Generator, it

may be used for programming. The advantage of using a Slave

Commander for programming is you can continue to operate your layout

while programming with the Slave Commander.

• Full selection of all locomotive and accessory addresses.

Error Messages:

• Er1 - A short circuit has been detected on the programming track. Check

the decoder installation, making sure the motor and all rail pickups are

insulated from each other.

• Er2 - No value was found during the readout of the selected register, or

no response was received from the decoder. However this does not mean

the decoder did not accept the new value. Try running the locomotive with

the new values before attempting to reprogram. Also, make sure the

locomotive is on the program track, and the program track is connected to

terminals P & Q on the Commander.

• Er3 - The speed of the locomotive you are adding to a Consist is not set to

0 (fully CCW). Press Exit to return to the locomotive display, set the speed

fully CCW, and then add the locomotive to the Consist.

• Er9 - The Commander is set in Slave Mode and is not connected to an

active XpressNET. See page 24 for instructions to set your Commander in

the proper mode.

Y 1

3 1

1 2 ... 9 10 11 12 13 14 15 16

Sin comentarios

Void INFINITE QX 6 Manual de instrucciones Pagina 14